P80 Gearbox: Custom Configuration, 144:1, 1 CIM Mount

Price: $164.00
Code: P80C-4433
Custom P80 Gearbox.
Specifications | ||||
Reduction | : 144:1 | Mounting Kit | : P80B-H44 | |
Stages | : 4 - 4:1, 4:1, 3:1, 3:1 | Pinion | : P80P-GM44 | |
Planet/Sun Gear Material | : Cold Rolled 4140 Alloy | |||
Ringgear Material | : Configurable | |||
Gear Specs | : 0.8mod, 20deg PA | |||
Weight | : Varies | |||
Length | : 4.5 in | |||
Height/Width (Square) | : 2.5 in | |||
Shaft Diameter | : 0.50 in | |||
Shaft Length | : Varies | |||
Shaft Key | : Varies | |||
Shaft End Tap | : Varies | |||
Mounting Holes | : Varies |
SOME ASSEMBLY REQUIRED
Gearbox will be delivered assembled and tested; however, it will need to be disassembled to grease and mount the motor prior to use. No special tools are required, typically only an allen wrench.
GEARBOX MUST BE GREASED
Prior to use the gearbox must be greased, grease IS NOT INCLUDED and must be purchased separately. We recommend Mobil XHP 222 Special grease; however, most lithium based ball bearing grease can be used. We do not sell grease separately, it can be readily purchased from most local auto parts stores or online suppliers such as MSC, Grainger, and McMaster among others. Custom gearboxes can be supplied greased.
MOUNTING HARDWARE INCLUDED
Gearbox includes one mounting kit. Mounting kit contains everything required to mount 1 CIM motor including pinion, screws, and spacer to attach the motor to the gearbox. (Mounting kit not included by default with custom gearboxes, it is an option.)
IMPORTANT NOTE
Mounting a large load to the end of an unsupported shaft may damage the gearbox. The shafts on these gearboxes are supported by two ball bearings making them fairly rugged; however, we do not recommend them to be used with large overhung loads. We recommend using a design that supports the end of the shaft. If it is not possible to support the end of the shaft, we recommend mounting the load as close to the face of the gearmotor as possible and cutting the shaft to length. Our 2.5in square, 1/2in shaft bearing block provides a simple and effective way to support the shaft.
MAXIMUM TORQUE RECOMMENDATION
We recommend maximum torque not exceed 85 ft-lb for all P80 Series Gearboxes. It is possible to mount motors that will exceed this in higher gear reductions. Higher reduction gearboxes should be utilized primarily for speed reduction. Designs utilizing a P80 gearbox / motor combination that will exceed 85 ft-lb should include a method of limiting torque to prevent damage to the gearbox.